Male-Female Jumper cable (20cm) 1PCS

These premium jumper wires are a little over 7.5″ (20cm) long and come in a ‘strip’ of 40 (4 pieces of each of ten colors). They have 0.1″(100 mil) sockets on either end and fit cleanly next to each other on standard-pitch 0.1″ (2.54mm) header. You can always pull the ribbon wires off to make individual jumpers, or keep them together to make neatly organized wire harnesses. And with these features, this jumper wires is very suitable for Raspberry Pi 3 board. The GPIO on Raspberry Pi 3 is pre-soldered with 20×2 header pins.

Note: The length of the jumper wires is sometimes a bit longer than what is listed.